HEEELLLLPPPP TS250X 1984 jet 6fjv54

[Timbo67]

Hi Suzuki guys,

A very big thank you goes to James for helping out with a needle. I was being ham fisted with my old one whilst inspecting pit marks on the needle which I had never seem before. I too tried to work out tapers to match up with no success.

Cheers

Tim

[evo550]

Tried any wreckers?
You could also try Show and Go.

[James P]

See my reply in the Wanted section.

Regards,
James

[LWC82PE]

Tell me the suzuki part number for this please and i will see what i can find.

[OverTheHill]

https://www.cmsnl.com/suzuki-ts250x-1984-e-e01-e04-e17-e18-e21-e24_model14192/neelde-jet-6fjv54-4_1338313a00/#.WsbpJdTwYdU
Do you mean the 'jet needle' as apposed to the 'needle jet'?, another forum suggested try this crowd http://www.smebike.com/index.php?route=common/home
Have a look through these to maybe compare dimensions & might find something close. https://www.ebay.com/sch/Mikuni-Motorcycle-Jet-Needles/177773/bn_33498779/i.html?_fsrp=1
 

[Doc]

Part number is 13383-13A00 jet needle. Indeed they are extremely rare.

[Andrew L]

Better be more careful with mine when i pull it apart next time didn't realize they were so hard to get what about an necj needle from an rm250 have to be close

[80-85 husky]

not a lot of similarly btw the ts x and the rm. have you ridden them?

[Andrew L]

I have , I owned an 87 rm250 in the past and I own a ts250x 84 model , both have very similar flat slide mikuni but after looking at the parts list the needles for the rm are discontinued for it as well and the later ones have a keihn carb which the necj needle i suggested is from , so not much help there , maybe mikuni oz might suggest a similar replacement , the TM series carbs look the same
http://www.mikunioz.com/flat-side-carbs-non-pump/

http://www.mikunioz.com/product-category/jets/mikuni-jet-needles/.

[Wasp]

I had exactly the same problem with the carbs on my triples . All jets and needles are Kawasaki parts and most obsolete or out of range  . There are only used mangled parts available on the net from USA or UK  at high cost . Got 3 new round slides from Sudco ( they look very similar to the OEM H2 carbs) . Now I can buy all the parts for tuning , cheap and new . The old 30 mm  carbs went on Ebay and I got  nearly as much for them as I paid for the new 32 mm Round slides. That made me and some purist happy . Just a thought .

[cloggy]

 I had the same problem with a SP370 jet needle It's a special made for suzuki part, not a standard mikuni part. Allens Performance knew the profile from the coding and also knew that there was no mikuni part which matched, or was even close as it was a double taper needle