Author Topic: 1980 PE 250 tank (Read 2835 times)

kipo · « **on:** July 13, 2016, 12:21:28 pm »

Just restored this 1980 PE 250 but usual story when i put fuel in the tank it split. The only thing I can find close is Just Gas Tanks and Clarke Tanks make after market for a 1980 RM 250 -400. Has anyone fitting one of these to a PE 250? Thanks for any advice.

Terrapista · « **Reply #1 on:** July 13, 2016, 12:37:23 pm »

Hi. If you go to page 3 of this forum theres heaps on your tank.
Good luck with it.

LWC82PE · « **Reply #2 on:** July 13, 2016, 12:54:59 pm »

http://forum.ozvmx.com/index.php?topic=39586.0

kipo · « **Reply #3 on:** July 13, 2016, 01:51:13 pm »

Thanks blokes

frostype400 · « **Reply #4 on:** July 13, 2016, 06:27:05 pm »

Nice looking bike well done I think your better to leave it drained and cap off when not in use a lot do it seen yamaha it tanks do the same I have so many pe tanks for this reason but I think only one I have has split which was split when I got it.

Oldfart · « **Reply #5 on:** July 13, 2016, 06:31:09 pm »

There is a product called Creme ( spelling ??) that will line your tank.
I have used it, and works a treat.

LWC82PE · « **Reply #6 on:** July 15, 2016, 10:45:53 pm »

http://www.kreem.com/fueltankliner.html

If its this one, i have used plenty of times in metal tanks and its fine for those but i am not so sure about using it in plastic tanks. The directions specifically say not for use in/compatible with plastic tanks.

OzVMX Forum

Author Topic: 1980 PE 250 tank (Read 2835 times)

kipo

1980 PE 250 tank

Terrapista

Re: 1980 PE 250 tank

LWC82PE

Re: 1980 PE 250 tank

kipo

Re: 1980 PE 250 tank

frostype400

Re: 1980 PE 250 tank

Oldfart

Re: 1980 PE 250 tank

LWC82PE

Re: 1980 PE 250 tank