Actually I am loving this hoarding thing(as long as no one calls that hoarders show).
A few months ago I bought a
new container.
The fit-out was then delayed by a new job. Then forfeited job, and unable to finish fit-out because of busted shoulder.
Upside, OK enough now, whilst the weather is fine I am back working on the Hoardanizzer.
Hope to have it finished in a few days(week
).
With heavy Gal angles inside purlins to stiffen them.
They will latter support a tropical roof to protect against daily heat and nightly condensation.
Vents sealed, and de-humidifier fitted.
Load rated to support internal 12mm all thread droppers to suspend gal 50mm angle. That will support the front edge of internal upper side shelving.
The idea is that it will use upper suspended space down each side that would be other wise lost.
My project roller dungers will go underneath. They will have their handlebars and their foot pegs removed. That will allow them to be packed in like sardines under the suspended shelves, with lounge cushions of the council clean up between them, to protect them from each other. A short piece of 22mm pipe through their bar mounts to provide steering maneuverability.
An upper suspended wheel and tyre rack is part of the right hand shelving arrangement.
I have so far purchased $600 worth of these type of nylon fish boxes, more to come.
The fish boxes fit in the upper shelves for project sorting etc.