Allround Fork springs

[YSS]

Due to constant pressure , I have now decided to construct and make a run of chrome silicon forksprings  for all 34 mm forks.  OD 26 mm and freelenght 480 mm. That would also cater to take the PD Forkvalve.
The rate I consider to make is 4.5N / mm  ,I  hope that would even cater for  the NSW tracks . Any thoughts , anyone interested. 

[YSS]

Brent can you check for the XT 500 ? I think they should fit perfect into them too.

[gage]

Hello,
Do you make any fork springs to suit a Honda CR125M? My manual doesn't have any specs for the wear limit on the springs - they are 509mm & 510mm respectively, so I'm not sure if they're past their use by date.

Regards, Ron

[YSS]

Whats the OD of your springs?

[brent j]

Walter,

I have both straight and offset axle XT forks here and a day off on Friday so I'll check both and let you know.
Both XT and TT use 36mm forks but the smaller OD springs will fit

I think that rate will be fine for an XT/TT,

Brent

[YSS]

If we make OD 24  26 and 28  that should cover many models. The rest we can make up with preload spacers , I think .

[gage]

The CR125M springs are 22.50 mm O.D. and the tube is 25.00mm inside diameter

[YSS]

Dont get fooled by the thread , measure  at least 50 mm down the tube .

[Tim754]

Hey Mr YSS you make an all square fork spring? Some of those old Eastern block countries most likely used um....

[YSS]

How many do you need Tim ? Remember the corner will be be the weakest point 

[Lozza]

The $$

[Nathan S]

The rate I consider to make is 4.5N / mm  ,I  hope that would even cater for  the NSW tracks . Any thoughts , anyone interested. 

I'm interested! 4.5N/mm - suitable for a semi-fat, semi-slow bloke like me?

Discount for bulk buy? 

[YSS]

Yes there will be bulk possible buying . But Les and Fernando will be in the box seat  unless  your numbers are 2 digits