Author Topic: Wanted 1979/80 CR125RZ/RA/RB Transmission washer 90457-700-305  (Read 710 times)

0 Members and 1 Guest are viewing this topic.

Offline SteveG47

  • Novice
  • *
  • Posts: 3
    • View Profile
Hi Guys,

Can anyone help, I'm looking for a 15mm Thrust Washer Part No. 90457-700-305.  it sits on the l/hand side of the countershaft on a CR125 RZ /RA / RB, (spigot end, opposite end to the front sprocket)

Or, if anyone has a decent Countershaft off a 1979/1980 CR125RZ or CR125RA with this washer on it I would consider that too.

Cheers,

Steve.

Offline Rookie#1

  • Legend
  • *****
  • Posts: 1744
  • JUST SHUDDUP AND RIDE IT!!!
    • View Profile
Re: Wanted 1979/80 CR125RZ/RA/RB Transmission washer 90457-700-305
« Reply #1 on: May 02, 2013, 08:24:41 pm »
Tippin you're a Honda man Steve, feel free to tell us a little about yourself and you're bike passion when you've got a chance. Have you already checked all the usual parts websites for what you're after?
THE SEXMAX.....coming soon to an Evo race near you!!! Lining up right along side the soon to be released TEDMAX!!!


CHECK OUT THE NEW FACEBOOK PAGE FOR VERi. VINTAGE ENDURO RIDERS INCORPORATED.

.https://www.facebook.com/pages/VERi-Vinduro/169617676550236

Offline SteveG47

  • Novice
  • *
  • Posts: 3
    • View Profile
Re: Wanted 1979/80 CR125RZ/RA/RB Transmission washer 90457-700-305
« Reply #2 on: May 03, 2013, 11:42:37 am »
Yes Rookie, I have always been mainly hooked on the red ones, Off and On Road!
Currently have a CR125RY just for a bit of fun with my youngest, but I'm also rebuilding an RA motor (slowly).
I am on the look out for an old RZ/RA basket case to play with.. the RH chain driven Elsinores are of the era I grew up in  :)

I've googled websites, Ebay, David Silver in the UK etc, sounds like this washer was made obselete by Honda a long time ago, even the complete shafts I see on Ebay in the States do not seem to have them fitted (I think it must stick on the inside of the LH case on disassembly and gets lost/mislaid).

Even if I can get the thickness of one I could then make one up - it is just a plain hardened thrust washer..

Cheers,

Steve.