« previous next »
Pages: [1]   Go Down

Author Topic: CR125M jetting  (Read 1169 times)

0 Members and 1 Guest are viewing this topic.

Offline suzuki27

  • Legend
  • *****
  • Posts: 853
    • View Profile
CR125M jetting
« on: May 14, 2012, 04:28:54 pm »
Can anyone help with jetting specs for a 30-32mm round slide Mikuni to be put on a 75 CR125? Cheers.
Logged

Offline suzuki27

  • Legend
  • *****
  • Posts: 853
    • View Profile
Re: CR125M jetting
« Reply #1 on: May 15, 2012, 06:58:35 pm »
Was that a rude question or is it tightly held info?
Logged

Offline 09.0

  • Legend
  • *****
  • Posts: 1244
    • View Profile
Re: CR125M jetting
« Reply #2 on: May 16, 2012, 06:52:56 pm »
I think the latter.
I have a pre jetted 32 that if you are patient I will get back to you with the info. It hasn't been put on the bike yet.
Logged

Offline suzuki27

  • Legend
  • *****
  • Posts: 853
    • View Profile
Re: CR125M jetting
« Reply #3 on: May 16, 2012, 08:38:21 pm »
Sounds good 090.
Logged

Offline Lozza

  • Legend
  • *****
  • Posts: 4206
    • View Profile
Re: CR125M jetting
« Reply #4 on: May 17, 2012, 12:24:28 pm »
Quote from: suzuki27 on May 15, 2012, 06:58:35 pm
Was that a rude question or is it tightly held info?

How about using the 'search' function? Because after an exhaustive 15 second search I found the question had been covered at least 3 times prior. Someone was even kind enough to post this link


http://www.braigasen.com/Mikuni_jetting_chart_two_stroke.htm
Logged
Jesus only loves two strokes
Pages: [1]   Go Up
« previous next »