Author Topic: Honda CR125M crank seal source (Read 2099 times)

nifty · « **on:** January 12, 2012, 08:03:04 am »

Trying to locate an Aus source or anyone that may have a stock of crank seals to suit the Honda CR 125M engine, 1974. The seal I require is the 28 x 56 x 9, Honda part 91203-360-003.

Noel · « **Reply #1 on:** January 12, 2012, 09:18:30 pm »

Hi Nev.
the last seals I got from Craig at MMT,
I think they were Pro x, the set before that from Red Devil had Kawasaki part numbers on them.
Hth.
Cheers
Noel

Lozza · « **Reply #2 on:** January 12, 2012, 11:31:17 pm »

I have a Pro-X one here but it is by 8mm wide not 9mm

nifty · « **Reply #3 on:** January 13, 2012, 07:22:14 am »

Thanks Noel & Lozza, I'll try Craig as I'll have to take the crank to him at any rate, snapped the pin in half at Buladelah, not sure why there was no heat stress evident!

Shaun G · « **Reply #4 on:** January 13, 2012, 09:30:12 am »

Hey Nev I got my last set for the '76 off Bruce so maybe you could get them from Les now???
Cheers
Shaun

nifty · « **Reply #5 on:** January 15, 2012, 10:03:59 am »

Shaun, Magoo supplied my last one as well, good thought, I'll try Les when he returns from holidays. Cheers.

Stewart Allen · « **Reply #6 on:** February 12, 2012, 02:08:37 pm »

Hi Nev,
I have a couple if you are still looking.

Cheers
Stewart

bazza · « **Reply #7 on:** February 12, 2012, 02:59:31 pm »

"Econohonda" New Zealand

OzVMX Forum

Author Topic: Honda CR125M crank seal source (Read 2099 times)

nifty

Honda CR125M crank seal source

Noel

Re: Honda CR125M crank seal source

Lozza

Re: Honda CR125M crank seal source

nifty

Re: Honda CR125M crank seal source

Shaun G

Re: Honda CR125M crank seal source

nifty

Re: Honda CR125M crank seal source

Stewart Allen

Re: Honda CR125M crank seal source

bazza

Re: Honda CR125M crank seal source