Author Topic: CR500 Gears  (Read 1256 times)

0 Members and 1 Guest are viewing this topic.

Power Stand

  • Guest
CR500 Gears
« on: September 02, 2009, 07:11:44 pm »
I am after two gears to finish off my gear box.

Gears wanted 23431-ML3-000 2nd output & 23481-ML3-000 5th input

Help really appreciated :)

Offline motomaniac

  • Legend
  • *****
  • Posts: 2448
    • View Profile
Re: CR500 Gears
« Reply #1 on: September 02, 2009, 07:23:55 pm »
5th gera is listed as available from www.cmsnl.com

Offline Hoony

  • Legend
  • *****
  • Posts: 4308
  • Melbourne, Vic.
    • View Profile
Re: CR500 Gears
« Reply #2 on: September 02, 2009, 07:37:42 pm »
That is until you place an order then it will more than likely come back as NLA
Long time Honda Fan, but all bike nut in general, Big Bore 2 stroke fan.    http://www.youtube.com/watch?v=XJoKP6MawYI
1985 Honda CR500RF "Big Red"
1986 Honda CR250RG
2005 KTM 300EXC "The GruntMeister" ( I love that engine)

rls840

  • Guest
Re: CR500 Gears
« Reply #3 on: September 02, 2009, 08:30:38 pm »
For this part number (23481-ML3-000) Try : Goldfields Bikeworks, Phone : 08 90218010 They are supposed to have one in stock.

Power Stand

  • Guest
Re: CR500 Gears
« Reply #4 on: September 02, 2009, 11:41:39 pm »
Thanks again guys, I will give them a call in the morning :)

Power Stand

  • Guest
Re: CR500 Gears
« Reply #5 on: September 04, 2009, 12:28:44 pm »
For this part number (23481-ML3-000) Try : Goldfields Bikeworks, Phone : 08 90218010 They are supposed to have one in stock.

Thanks for the tip, old stock listing though  :(

Offline Lozza

  • Legend
  • *****
  • Posts: 4206
    • View Profile
Re: CR500 Gears
« Reply #6 on: September 04, 2009, 02:34:34 pm »
No luck in Japan, but if your desparate I do know a place you could get the gears made at a 'reasonable' cost. PM me if you want details
Cheers
Jesus only loves two strokes

Power Stand

  • Guest
Re: CR500 Gears
« Reply #7 on: September 04, 2009, 05:09:57 pm »
No luck in Japan, but if your desparate I do know a place you could get the gears made at a 'reasonable' cost. PM me if you want details
Cheers

I am not desperate yet,,,,, but a contact for a gear cutter would be nice, I will send a PM. :)