« previous next »
Pages: [1]   Go Down

Author Topic: 35 t press in brissy.  (Read 1351 times)

0 Members and 1 Guest are viewing this topic.

Offline evo550

  • Legend
  • *****
  • Posts: 2435
    • View Profile
35 t press in brissy.
« on: November 06, 2008, 02:06:25 pm »
Anyone know of a 35ton press in brisbane to press out crank pin ??
Serco have tried but only go to 20t and didn't budge it.
Logged

Offline vandy010

  • Legend
  • *****
  • Posts: 1982
  • #789 MX125a BMCC Brisbane
    • View Profile
Re: 35 t press in brissy.
« Reply #1 on: November 06, 2008, 11:18:13 pm »
PM sent
Logged
"flat bickie"

Offline maicomc490t

  • Legend
  • *****
  • Posts: 551
    • View Profile
Re: 35 t press in brissy.
« Reply #2 on: November 08, 2008, 11:21:56 am »
If you get stuck send it on down to Sydney - my 35T makes short work of most anything and I have a good range of platten plates to suit most cranks and can always cut more if required.
Cheers
Dave Mac
Logged
VAPOUR (AKA HYDRA / HYDRO / AQUA / WET) BLASTING AND GENERAL ENGINEERING 0416074750 (or) [email protected]

DUCATI Parts wanted esp 450 R/T and other early models inc V-twins

BULTACO M49 parts wanted

Offline TT5 Matt

  • Legend
  • *****
  • Posts: 1538
    • View Profile
Re: 35 t press in brissy.
« Reply #3 on: November 11, 2008, 12:10:24 am »
got a pic or drawing of a plattern plate so i can make one at tafes machining hobby course [homer course] that i attend.



TT5 Matt
Logged
Pages: [1]   Go Up
« previous next »