« previous next »
Pages: [1]   Go Down

Author Topic: bultaco reed valve  (Read 3770 times)

0 Members and 1 Guest are viewing this topic.

Offline slider84

  • Novice
  • *
  • Posts: 21
    • View Profile
bultaco reed valve
« on: November 04, 2008, 01:58:38 pm »
does any one have a reed valve from a late modle pursang 250.
[email protected]
Logged

montynut

  • Guest
Re: bultaco reed valve
« Reply #1 on: November 04, 2008, 09:39:07 pm »
Hey Ross,
Have you found out which model KTM the reed block assembly comes from for the 250H7? Please please please!!
Logged

Offline slider84

  • Novice
  • *
  • Posts: 21
    • View Profile
Re: bultaco reed valve
« Reply #2 on: November 05, 2008, 10:51:06 am »
the bolt pattern is 35 x 70. can you post a pic of the ktm block.
Logged

montynut

  • Guest
Re: bultaco reed valve
« Reply #3 on: November 05, 2008, 07:15:08 pm »
Ross,
Sounds like your H7 is the same as mine. The rubber connector to the carbie is original. At this stage it appears OK but I am afraid to touch it as I think it would probably fail if I do. The actual reed block seems OK.
Logged

mx250

  • Guest
Re: bultaco reed valve
« Reply #4 on: November 06, 2008, 02:30:09 pm »
Quote from: slider84 on November 05, 2008, 10:51:06 am
the bolt pattern is 35 x 70. can you post a pic of the ktm block.

I don't know the model number but my Monty reed looks like.....



does that help ??? ::)
Logged

mx250

  • Guest
Re: bultaco reed valve
« Reply #5 on: November 06, 2008, 08:42:20 pm »
Quote from: 390 Ross on November 06, 2008, 07:58:36 pm
Yup. That's the one. Is that connector any good Graeme and how much?
Its a good 'un Rooss but sorry, it's a keeper. Without it it would make the whole engine pretty useless ::).

I didn't mean to be a tease but rather to help along the discussion to identify the Monty reed :-[.
Logged
Pages: [1]   Go Up
« previous next »