« previous next »
Pages: [1]   Go Down

Author Topic: Lathe sizes  (Read 1960 times)

0 Members and 1 Guest are viewing this topic.

Offline Mike52

  • Legend
  • *****
  • Posts: 1834
  • 81 KTM 125 LC
    • View Profile
Lathe sizes
« on: July 27, 2015, 09:17:47 am »
Just right  ;D
Logged
85/400WR,86/240WR,72/DKW125,Pe250c,TC90,TS100,XT250,86/SRX250,XR400r
Friend  struggling up a hill on a old bike at MTMee .http://www.youtube.com/watch?v=cjj6E2MP9xU.

Offline alexbrown64

  • Legend
  • *****
  • Posts: 715
    • View Profile
Re: Lathe sizes
« Reply #1 on: July 27, 2015, 09:15:00 pm »
Can you get those at Bunnings Mike?
Logged

Offline Slakewell

  • Legend
  • *****
  • Posts: 3577
  • Slakewell Motordrome
    • View Profile
Re: Lathe sizes
« Reply #2 on: July 28, 2015, 08:13:06 am »
Chesterfield Triumph 2000 if you can find one is the perfect VMX's lathe
Logged
Current bikes. KTM MC 250 77 Husky CR 360 77, Husky 82 420 Auto Bitsa XR 200 project. Dont need a pickle just need to ride my motorcickle

Offline OverTheHill

  • Legend
  • *****
  • Posts: 801
    • View Profile
Re: Lathe sizes
« Reply #3 on: July 28, 2015, 08:37:09 am »
Gosh, i could do with that as have an egg shaped 21 conical suzuki wheel brake drum [from road racing in an RT2 with RT2mx top end] & only have a small lathe. In saying that i could just spin one of my RT2 cylinders to de-stroke it [64mm DT1 crank] after trimming the fins in my 'cut off wheel' [don't tell anyone]. Had a 'big' lathe at work ['big' belt driven] & could do most anything in that. The 4 jaw chuck was about as much as i could lift to fit it on. Memories eh!!.
Logged
Pages: [1]   Go Up
« previous next »