« previous next »
Pages: [1]   Go Down

Author Topic: PE 250Z float height  (Read 1211 times)

0 Members and 1 Guest are viewing this topic.

Offline 80-85 husky

  • Legend
  • *****
  • Posts: 3847
    • View Profile
PE 250Z float height
« on: August 06, 2014, 08:53:37 am »
ive seen a pic of the float height adjustment for the PE (10.7mm) but cant find it... need to know what to measure from to..etc

cheers
Logged

oldfart

  • Guest
Re: PE 250Z float height
« Reply #1 on: August 06, 2014, 09:22:18 am »
Turn carb up side down and measuring at    ( B )  10.2 to 11.2  is between the float tongue and  the needle jet  base.
 page 126  Clymer manual    and pic on page 123  ;)
« Last Edit: August 06, 2014, 09:25:37 am by oldfart »
Logged

Offline 80-85 husky

  • Legend
  • *****
  • Posts: 3847
    • View Profile
Re: PE 250Z float height
« Reply #2 on: August 06, 2014, 06:02:00 pm »
found it later today, thx ;)
Logged
Pages: [1]   Go Up
« previous next »