anyone nead any casting made for old bikes

[farmer58za]

C11 - 4 stroke
Bantam - 2 stroke
Both would need work to make them smooth. They were sand cast originally.
Regards
David

are thay 2 stroke or 4  between the fines must be  smooth ass babies ass to get sand to slide out even then pain in ass job it would be but possible

[Dono113]

I think you have found a market for your work KDX, I just picked up a 69 TS 250 and need to magnento cover would get two or three of off you as have spare motors. The one on the bike is a handmade brass one and adds 4 kilos to the bike , cant seem to find these covers OS.
Cheers
Dono

[crmarty]

How did the waterpump housing/clutch cover for the CR250RE perform after riding the bike?

What do you think will be the cost of reproducing the covers?

[kdx 175]

im rideing the cr 250 at mp on my way up to Toowoomba this weekend see how to goes it's ok up and down my street until cops come   cost 350$ there not rite yet more work to do but getting there

[FourstrokeForever]

The ole fun killers never stop KDX. I guess you'll have to make an extra cover now to make up for the $350 donation!

[kdx 175]

clutch cover pump worked good temp never got over 67 c at echo valley guna make ten very soon   

[squirtmoto]

FWIW had a look at the cover today at Toowoomba, looks sand cast like factory, and worked well, he had no dram's with temp or any other issues. I for one will be ordering one and at $350 bucks, you find one NOS, good luck!!

[Simo63]

FWIW had a look at the cover today at Toowoomba, looks sand cast like factory, and worked well, he had no dram's with temp or any other issues. I for one will be ordering one and at $350 bucks, you find one NOS, good luck!!

This is for the CR250RE?  If so I'll take one of those 10 as well please.

[Stewart Allen]

Put me down for one please.

[kdx 175]

I let you guys no when I got sum to sell its a big job

[rob]

G'day KDX 175,
Nice to know that some one is skilled in this form of work as I think there should be a big enough market out there for you to make a real go of it.
My question is are you able to reproduce cases and covers in magnesium ?

Kind regards
Rob.

[kdx 175]

I have cast magnesium but cant do it at home my shed is 4 m x 4m no room and  it will kill all  the birds uses to much sulphur in the proses maybe latter if I go full time im just starting this project sea how far it goes thanks for feed back im trying my goodest   

[kdx 175]

I have made 10 I have 9  clutch cover for 1984 cr 250  cnc man killed one  I need sum one to buy one to tel me if there's any problems I have hade trouble needed weld on gear lever stoper cnc man again pm me your phone number I try get photo up 

[kdx 175]

[VMX Andrew]

Wow !!! Top work im impressed, they are the most sought after item on all the watercooled Honda CRs.
You should be able to make a bit of money outa that lot.