CR125M1 Crankshaft

[miniwheels]

Hi , just wondering if anybody can help me with some info as I am trying to rebuild my CR125M1 crankshaft, I recently found a new connecting rod P/N 13201-360-310 that has two notches in it but what confuses me apart from the Honda chart is what big end pin and the needle bearing P/N's I need for that connecting rod  .

[bigk]

There are better (stronger) options for rods than std NOS, especially if you are to race the bike.
K

[miniwheels]

Hi Big K, this crank is for a sleeved down 100cc M1 elsinore, I have heard that the later conrods are stronger with some modifying of the crank halves to fit the o/s pin but I am not sure which model CR and the availibilty of parts and who can do it, any leads big K .

[bigk]

Any engineer worth their salt could do it, Where are you located? I have rod kits here, and get the webs done locally, or you can use a Yamaha go cart rod and not bore the webs, but that works out expensive. I am in Bendigo, Victoria & can handle it if you can't find anyone close to you.
Cheers,
K