« previous next »
Pages: [1]   Go Down

Author Topic: Pursang/mikuni jetting  (Read 3497 times)

0 Members and 1 Guest are viewing this topic.

Offline huskibul

  • Legend
  • *****
  • Posts: 824
    • View Profile
Pursang/mikuni jetting
« on: July 03, 2012, 10:01:32 am »
    Wanted  72' 250 pursang / 36mm mikuni conversion baseline jetting specs - any info much apreciated  :)
Logged

Offline Matador107

  • B-Grade
  • ***
  • Posts: 235
    • View Profile
Re: Pursang/mikuni jetting
« Reply #1 on: July 03, 2012, 05:41:10 pm »
Go to club bultaco australia site and look up technical section,lots of carby info for Pursang/Mikuni set up there. Cheers.
Logged
Bultaco Metralla, Matador MK 5, Montadero mk2, El Bandido model 18,plus lots of bits and two Honda XR's 250,350.

Offline Moto

  • A-Grade
  • ****
  • Posts: 326
    • View Profile
Re: Pursang/mikuni jetting
« Reply #2 on: July 03, 2012, 06:04:31 pm »
These are the settings from the CBA site Mk 6 250 Pursang 106 courtesy of Mark Austin

  Mikuni 36mm
Main      270
Pilot        35
N-Jet     Q-5  (159)
Needle     6DH3
Slide       2.5
Needle    Mid pos     
Logged

Offline huskibul

  • Legend
  • *****
  • Posts: 824
    • View Profile
Re: Pursang/mikuni jetting
« Reply #3 on: July 03, 2012, 06:41:01 pm »
   Thanks for that moto & matador gives me a starting point - cheers  :)
Logged
Pages: [1]   Go Up
« previous next »