« previous next »
Pages: 1 [2]  All   Go Down

Author Topic: Clever; I Wish I had Thought of That......  (Read 2798 times)

0 Members and 1 Guest are viewing this topic.

Offline BultacoMacca

  • B-Grade
  • ***
  • Posts: 249
    • View Profile
Re: Clever; I Wish I had Thought of That......
« Reply #15 on: February 25, 2011, 11:33:23 pm »
You can buy those Slide Hammer type seal & bush pullers from your friendly gold encrusted 'Snap-On' toolman.
Logged

mx250

  • Guest
Re: Clever; I Wish I had Thought of That......
« Reply #16 on: February 26, 2011, 06:27:58 am »
Quote from: BultacoMacca on February 25, 2011, 11:33:23 pm
You can buy those Slide Hammer type seal & bush pullers from your friendly gold encrusted 'Snap-On' toolman.
I think the dynabolt would be a wee bit cheaper ;) :P.
Logged

Offline pancho

  • Legend
  • *****
  • Posts: 2375
    • View Profile
Re: Clever; I Wish I had Thought of That......
« Reply #17 on: February 27, 2011, 05:25:02 pm »
Hey slakewell, using brass or aluminium is not recmended for nocking out or in bearings,gears, etc as little pieces get into places undesirable.
 I always use a piece of mild steel [not hardened] with any burrs ground off. 
 cheers pancho.
Logged
dont follow me i'm probably off line!
Pages: 1 [2]  All   Go Up
« previous next »