Author Topic: CHECK TIMING ON DT360A  (Read 1585 times)

0 Members and 1 Guest are viewing this topic.

Offline jimg1au

  • Legend
  • *****
  • Posts: 3489
    • View Profile
CHECK TIMING ON DT360A
« on: May 14, 2008, 08:22:38 am »
hi
i have a dt360a and i need to check the timing.the manual says use a dial indicator but i dont have one.is there any other way of checking this.i am replacing the key in the crank.i have a puller to get the mag off.
cheers
jim

Offline Lozza

  • Legend
  • *****
  • Posts: 4206
    • View Profile
Re: CHECK TIMING ON DT360A
« Reply #1 on: May 14, 2008, 12:21:22 pm »
Give me a ring Jim,I'll talk you through it
Cheers
Jesus only loves two strokes

Offline pancho

  • Legend
  • *****
  • Posts: 2375
    • View Profile
Re: CHECK TIMING ON DT360A
« Reply #2 on: July 31, 2008, 05:07:02 pm »
g,day jim. you were asking about jet sizes for your 360 .i still havnt found  my book but i found another piece re-carby fitted to the rt2 model--- carby type-vm32sh mikuni i.d.mark-308e2....main jet-230.... needle jet 6dh3... clip pos 3... needle jet p-0.... cutaway3... pilot #45....starter jet #60... float level 21.4+-2.5mm ....also there is a rubber "o"ring on the bottom of the needle jet wich will make it run verry rich if not perfect  hope this may help cheers wally.
dont follow me i'm probably off line!