« previous next »
Pages: [1]   Go Down

Author Topic: CZ 400 74 model pivot pin removal  (Read 1875 times)

0 Members and 1 Guest are viewing this topic.

Offline VMX Andrew

  • Legend
  • *****
  • Posts: 961
    • View Profile
CZ 400 74 model pivot pin removal
« on: February 15, 2013, 05:27:23 pm »
Having heaps of trouble with this little sucker.
Any hints or tips much appreciated.
Regards
Andrew.
Logged

Offline tony27

  • Legend
  • *****
  • Posts: 1908
    • View Profile
Re: CZ 400 74 model pivot pin removal
« Reply #1 on: February 15, 2013, 07:08:44 pm »
It will be rusted to the rear engine mount, get the engine out & try heating the engine mount where it goes through a few times.
You should be able to remove the swingarm & mount in 1 piece which should make things easier
New pins & bush assemblies are easy to get, advertised on ebay quite often

 http://www.ebay.com/itm/cz-motocross-falta-125-250-360-380-400-NEW-SWINGARM-AXLE-/200893477575?hash=item2ec62f32c7&item=200893477575&pt=Motorcycles_Parts_Accessories&vxp=mtr

Never had this problem myself but it's not an uncommon problem, someone will no doubt reply later on that has been through doing this
Logged

Offline Husabergpete

  • Legend
  • *****
  • Posts: 561
    • View Profile
Re: CZ 400 74 model pivot pin removal
« Reply #2 on: February 21, 2013, 09:15:08 pm »
Have had a similar problem with Huskies - our CZ was no issue. But tipping it on the side and spraying penatrine in on a daily basis for a week or so will help then as mentioned add heat and steady as she goes.  All the best Pete
Logged
KTM 250 1980,  Maico 250 AW 1977, Husqvarna CR 430 1981, , CZ 250 1973 and a 550 Husaberg
Pages: [1]   Go Up
« previous next »