Cz rear spokes and axle

[mainline]

Where's a good(cheap if possible) source for spokes? I've got a wheel to build using an early 70's rear hub.
Also, would anyone have a spare rear axle for sale?
Cheers

[tony27]

From memory when I talked to Les earlier this year he had spokes in stock but not loaded onto the website

[GMC]

Keep in mind that the 74 & later axles are longer than the earlier models

[foxy999]

Ash's Spoked Wheels Brisbane
35 Crosby Road Albion Brisbane 4010 Ph: 07 3262 6447 Fax: 07 3262 4890 Email,  he done a great job on my 360 rear wheel. he even made a few spares for me.

[mainline]

Thanks guys, I've used Ash's before and can agree the service and product is pretty good. Handy to know they've made sets up before.

Keep in mind that the 74 & later axles are longer than the earlier models

Cheers Geoff, the swingarm the wheel is going into is 205mm externally, do you know which axle I'd be after in this case?

[GMC]

The 74 axle would suit a swingarm around 270 outside width.

The 73 and earlier CZ's had the swingarm tubes flattened which is why the axles are shorter, don't have the measurement for them on hand.

[tony27]

Pretty sure all pre74 axles would be very close to the same length, will be removing my rear wheel tomorrow & can measure it for you

[foxy999]

so what is this going on?

[mainline]

so what is this going on?

This will be going on the 350 BSA I'm building, if everything works out it'll be ready for the Nats

Pretty sure all pre74 axles would be very close to the same length, will be removing my rear wheel tomorrow & can measure it for you

That'd be great, thanks

[tony27]

Finally got the wheel out to lube the brake cam, sizes follow
Shaft diameter 17mm
Overall length from under head 225mm
Thread length 25mm
Thread diameter 16mm x 1.5mm pitch

[mainline]

Finally got the wheel out to lube the brake cam, sizes follow
Shaft diameter 17mm
Overall length from under head 225mm
Thread length 25mm
Thread diameter 16mm, will take to work & measure pitch tomorrow

Looks like that's the one I'm after, thanks for taking the time to measure that up

Cheers

[tony27]

My pleasure, had lots of help from other members so least I could do