yz250k advice needed….please.

[old n broken]

I am madly trying to get my yz250k ready for CD10, have just purchased a dg pipe and the instructions say re-jetting will be required.
any K owners out there that may know what size is needed?
Also i am rebuilding the rear wheel and the shop wants to know the offset….at the risk of sounding stupid, what is the offset, and how do i measure it??
any help greatly appreciated.

[Ted]

Take the tyre off the rim and give them the whole wheel intact. They can simply measure the offset themselves. Two seconds work with a straight edge and a tape measure

[smed]

I am madly trying to get my yz250k ready for CD10,

You have got plenty of time mate,in case you missed it,It's been cancelled :'(     http://forum.ozvmx.com/index.php?topic=30933.0

[old n broken]

too late... the original rim was so badly damaged,i cut it off and sent the hub to be relaced…its a reputable wheel building shop, i assumed they would know
all there was to know.??

[old n broken]

WHAT CANCELLED ??

[Nathan S]

WHAT CANCELLED ??

Yep.
http://forum.ozvmx.com/index.php?topic=30933.0

[old n broken]

Thanks smed for that info….major bummer, have been looking forward to cd10 for a long time as i missed cd9,
and have not ridden since cd8.
At this rate i will forget how to ride.

[smed]

There are a couple of different rides being organised for the same weekend not too far from Sydney I believe,anybody got further details please for MR O-N-B,gotta get him some seat time

[Ted]

Check out the Vinduro section for details

[smed]

too late... the original rim was so badly damaged,i cut it off and sent the hub to be relaced…its a reputable wheel building shop, i assumed they would know
all there was to know.??

You either need to take them the bike or at least the swingarm & axle assy so they can get the rim in the right spot or find someone who can measure there intact wheel & give you the specs,As far as the pipe goes you will have to test ride after fitting it & do a plug chop to see if it's rich or lean