1979 CR 250 Honda RZ brake pedal bushings.

[firko]

I urgently need 2 Honda brake pedal bushings, part #46512-360-300 (Part #12 in the below diagram) to fit a '79 CR250 RZ or 1980 RA. I can probably get them from the USA but I need them by next weekend. Can new ones be sourced here in Oz or can someone supply me with a used pair?  Please
                                                                               

[Slakewell]

Frank could knock them up for yeh in the lathe if you get stuck.

[firko]

Apparently the bushings I need fits all Honda CR'S from '74-80 as seen in the list below...
                                                                                     
                                                                                     

[bigk]

Just get some made, it's way easier.
K

[firko]

Frank could knock them up for yeh in the lathe if you get stuck.

Just get some made, it's way easier 

It's little thing like this that I miss being retired. I could have knocked 'em up out of Teflon in 10 minutes at work. I'll duck over to Franks tomorrow and get him to do 'em. I thought they might be a common old thing available at any Honda dealer but then I realised 1: Honda are hopeless and 2: there are no Honda dealers near here.

[oldyzman]

Try your local bearing supplier ask for a 2 x glacier bush with a flange. about $5 each, they worked on my 125RZ. NSW bearing supplies at fairfield will do it. They have a 1mm wall thick ness, you may have to trim them with a thin blade...
Brett