« previous next »
Pages: [1]   Go Down

Author Topic: Rod kit  (Read 1906 times)

0 Members and 1 Guest are viewing this topic.

Offline bigk

  • Legend
  • *****
  • Posts: 2655
  • Kangaroo Flat Victoria
    • View Profile
Rod kit
« on: April 11, 2008, 02:29:50 pm »
For anyone interested, ProX part number: 03-6642 rod kit, from a 95 Skidoo, will fit CR250M & Odessy, and also 1979/80 Suzuki RM250N/T.
Cheers,
K
Logged

Quicksilver

  • Guest
Re: Rod kit
« Reply #1 on: April 11, 2008, 06:22:19 pm »
Good to know. Good on ya for sharing the info.  ;)
Logged

Offline LWC82PE

  • Superstar
  • ******
  • Posts: 6006
    • View Profile
    • PE motorcycles & SuzukiTS.com
Re: Rod kit
« Reply #2 on: April 12, 2008, 09:13:30 am »
sounds good. that will mean it will fit PE's. i will have to check on this. i always knew a ski doo rod suposedly fits. when i got the new BB importers/pro x catalogue i measured my nos rod suzukiand compared to mesuremnents of skidoo rods but i couldnt find one exactly the same. there was one or 2 measurements a half to 1mm out. i will re-check aginst the specs for that part number though
Logged
Wanted - 1978 TS185 frame or frame&motor. Frame # TS1852-24007 up to TS1852-39022

Offline jimg1au

  • Legend
  • *****
  • Posts: 3489
    • View Profile
Re: Rod kit
« Reply #3 on: April 12, 2008, 09:18:03 am »
posted to the suzuki.do you have to put a spacer under the barrel or is it an exact fit .my hot rods kit came with a 4mm spacer for my 1973 cr250
cheers
jim
Logged

Offline bigk

  • Legend
  • *****
  • Posts: 2655
  • Kangaroo Flat Victoria
    • View Profile
Re: Rod kit
« Reply #4 on: April 12, 2008, 02:05:51 pm »
No spacer, and with regard to The RM fitment, yes the big end pin is .8mm shorter than the Suzuki item. You can buy a longer pin and a couple of extra thust washers or do what I did and just press the pin in a bit extra and have it inside the crank webs .4mm each side. No problems either way but cheaper doing it the ay I did.
Cheers,
K
Logged
Pages: [1]   Go Up
« previous next »