« previous next »
Pages: 1 2 [3]  All   Go Down

Author Topic: loosening a nut on a DT175  (Read 6452 times)

0 Members and 1 Guest are viewing this topic.

All Things 414

  • Guest
Re: loosening a nut on a DT175
« Reply #30 on: August 17, 2010, 06:52:17 am »
Threaten to chop off its kids fingers one by one untill it gives in.....
Logged

Offline Hoony

  • Legend
  • *****
  • Posts: 4309
  • Melbourne, Vic.
    • View Profile
Re: loosening a nut on a DT175
« Reply #31 on: August 25, 2010, 06:37:38 pm »
hey Oldbiker, did you get that bolt out yet or What ?
Logged
Long time Honda Fan, but all bike nut in general, Big Bore 2 stroke fan.    http://www.youtube.com/watch?v=XJoKP6MawYI
1985 Honda CR500RF "Big Red"
1986 Honda CR250RG
2005 KTM 300EXC "The GruntMeister" ( I love that engine)

Oldbiker

  • Guest
Re: loosening a nut on a DT175
« Reply #32 on: August 25, 2010, 07:27:23 pm »
nah, thanks for the help all of you lot. I'm concentrating on getting my IT400F going. I might take the DT down the bike shop and get them to check it out. Maybe some heat might loosen whatever is stopping the nut coming off.
Logged

Offline matcho mick

  • Legend
  • *****
  • Posts: 2279
    • View Profile
    • Moto Tumbi
Re: loosening a nut on a DT175
« Reply #33 on: August 25, 2010, 11:00:12 pm »
bunnings sell a Ozito eletrick rattlegun,$60,undoes ossa primary sprocket nuts in a blink,works for me, :P
Logged
work,the curse of the racing class!!
if a hammer dosn't fix it,you have a electrical problem!!

Oldbiker

  • Guest
Re: loosening a nut on a DT175
« Reply #34 on: August 26, 2010, 12:04:48 pm »
tried that too, no good
Logged
Pages: 1 2 [3]  All   Go Up
« previous next »