YZ125X / 125C Left CrankCase. & Cover. Will take whole motor..

[steveo247]

gday,

I'm looking for an undamaged left hand crankcase for my 125X.
Mine has been smashed from a chain and i'm hoping to find another good one, and use my mangled one for the race bike.

Im also looking for the crankcase cover for that side. T
heres a few on ebay, but if i can not have to ship these out from america id be much happier!

The crankcases are the same on the 125C and X, and i think the A/B cases would fit too? (can someone help with that?)
I'll take a whole motor if i need too!

Contact me on here,
or email on [email protected]

thanks very much.
steve.

[vandy010]

I'm looking for an undamaged left hand crankcase for my 125X.
The crankcases are the same on the 125C and X, and i think the A/B cases would fit too?

A/B will be different.
externally the magneto cover is different, internally i'm unsure.
i'm led to believe the TY175 is the same as the C/X but as usual, i've been wrong before.

[Freakshow]

what about the 76+ Dt 125 / 175 ?

[steveo247]

what about the 76+ Dt 125 / 175 ?

Dad thought that too. I can only go off part numbers, and they are different?

[Freakshow]

Ok well thats all i have for you.........

[Nathan S]

YZ125C/X and probably TY175 are the same.

The other likely candidates (DT, earlier/later YZes etc) are all different, in one way or another (usually relating to the shift drum and/or the rods the shift forks slide along, at least).

I've got a spare YZ-C case, but will have to confirm condition before making any big promises.
May also have a spare ignition cover too.

[steveo247]

YZ125C/X and probably TY175 are the same.

The other likely candidates (DT, earlier/later YZes etc) are all different, in one way or another (usually relating to the shift drum and/or the rods the shift forks slide along, at least).

I've got a spare YZ-C case, but will have to confirm condition before making any big promises.
May also have a spare ignition cover too.

looking forward to hearing your reply mate!

i think i have the cover sorted..

[Mick D]

YZ125C/X and probably TY175 are the same.

YES THEY ARE.

Here is a recent one I repaired



machined weldable piece.


welded, prior to invisible machining finish and dremal finish.

Run a twenty mm reamer through the finished repair, beautiful .

[steveo247]

YZ125C/X and probably TY175 are the same.

YES THEY ARE.

Here is a recent one I repaired



machined weldable piece.


welded, prior to invisible machining finish and dremal finish.

Run a twenty mm reamer through the finished repair, beautiful .

Thats a erally tidy repair mick-de!
If i cant find one, you'll have a PM !