OzVMX Forum

Clubroom => Tech Talk => Topic started by: suzuki27 on May 14, 2012, 04:28:54 pm

Title: CR125M jetting
Post by: suzuki27 on May 14, 2012, 04:28:54 pm

Can anyone help with jetting specs for a 30-32mm round slide Mikuni to be put on a 75 CR125? Cheers.

Title: Re: CR125M jetting
Post by: suzuki27 on May 15, 2012, 06:58:35 pm

Was that a rude question or is it tightly held info?

Title: Re: CR125M jetting
Post by: 09.0 on May 16, 2012, 06:52:56 pm

I think the latter.
I have a pre jetted 32 that if you are patient I will get back to you with the info. It hasn't been put on the bike yet.

Title: Re: CR125M jetting
Post by: suzuki27 on May 16, 2012, 08:38:21 pm

Sounds good 090.

Title: Re: CR125M jetting
Post by: Lozza on May 17, 2012, 12:24:28 pm

Quote from: suzuki27 on May 15, 2012, 06:58:35 pm

Was that a rude question or is it tightly held info?

How about using the 'search' function? Because after an exhaustive 15 second search I found the question had been covered at least 3 times prior. Someone was even kind enough to post this link


http://www.braigasen.com/Mikuni_jetting_chart_two_stroke.htm