Author Topic: WANTED. Forks to suit PE250B  (Read 2112 times)

0 Members and 1 Guest are viewing this topic.

Offline Canam370

  • Legend
  • *****
  • Posts: 1608
    • View Profile
WANTED. Forks to suit PE250B
« on: May 28, 2022, 09:45:33 pm »
ISO forks to suit a PE250B. RM250a/b and RM370 will also suit. Good chrome preferred but not essential. Whatcha got?
WANTED. Canams;all models,complete or parts.SWM stuff too!

I'm THE Thread Killer - when I post a thread dies!

Offline LWC82PE

  • Superstar
  • ******
  • Posts: 6006
    • View Profile
    • PE motorcycles & SuzukiTS.com
Re: WANTED. Forks to suit PE250B
« Reply #1 on: June 19, 2022, 06:37:42 pm »
Incase you don't know the PE forks are different to the RM. All the parts are different. Different length  damping rods, sliders, inner tubes, springs, travel
Wanted - 1978 TS185 frame or frame&motor. Frame # TS1852-24007 up to TS1852-39022

Offline Canam370

  • Legend
  • *****
  • Posts: 1608
    • View Profile
Re: WANTED. Forks to suit PE250B
« Reply #2 on: June 24, 2022, 07:15:13 pm »
All sorted. Used RM stanchions. All the PE bits fitted.
WANTED. Canams;all models,complete or parts.SWM stuff too!

I'm THE Thread Killer - when I post a thread dies!

Offline LWC82PE

  • Superstar
  • ******
  • Posts: 6006
    • View Profile
    • PE motorcycles & SuzukiTS.com
Re: WANTED. Forks to suit PE250B
« Reply #3 on: July 01, 2022, 08:16:03 pm »
PE250B

Slider – 345mm
Inner – 660mm


76/77 RM250 A/B

Slider – 355mm
Inner – 647mm


Fitting RM inner tubes will lower the front end. Probably not a good idea unless fitting shorter than standard shocks as well,  as the PE is already low at the front and kinda hunched forward in stock form. Check clearance between triple clamp, wheel and top of sliders for clearance when forks bottomed out.
« Last Edit: July 01, 2022, 08:18:21 pm by LWC82PE »
Wanted - 1978 TS185 frame or frame&motor. Frame # TS1852-24007 up to TS1852-39022