Wiring loom re-wrapping?

[1983_Enduro_YAMI]

G'day all,

I've recently purchased an Aus spec wiring loom for my IT250K.....it was looking a bit dodgy so i decided to replace all terminals and tidy up the wires by unwrapping it all...now it's all sorted and i'm ready to wrap it back up together...don't really wanna use electrical tape as they go gooey and comes off over time. What other options are you guys using apart from the electrical tape?

[Momus]

Sheathing, shrink tubing and silicon tape. You need to sheath and shrink tube before terminating.

[fred99999au]

Rare Spares sells loom tape which is shiny but not sticky. Sort of staticly sticks to itself but allows wire movement.

https://www.rarespares.net.au/rarespares/buy/b11666/wiring-harness-tape-10-wide-x-140-non-adhesive

[Wasp]

Wurth sells an amazing heat shrink . It goes from a generous 20 mm down 8 mm and still stays nice and flexible .

[Lozza]

You can buy non-adhesive loom tape or cloth tape on ebay, plastic over braid with heat shrink  works well or plastic spiral wrap. I normally go non adhesive tape and spiral wrap where the loom will be attached to the frame