Wanted: Yamaha RT-3 parts.

[joel510]

Hi guys,  Im in the process of building my old RT3 basket case into a low level pre-75 racer and need a few bits.  I know its a bit of a long shot but here are the bits on my wish list.

Mag cover.
complete seat or base.
either some resonable front fork tubes or complete units.
Aftermarket pipe of some sort.
And, after an almighty kick-back, a main drive shaft for the gearbox as it sheared off the kick-start idler pinion on the end.  Complete gearbox would be o.k. too.

Thanks guys and let me know if you have anything.
Joel.

[crossedup2]

Hi Joel

You can spread your net a little wider, the part is similar for DT2-3 as well as RT 2-3. (MX250 MX360 also)

The output shalf is a very common part and there are plenty on evilbay US.

Where are you located?

Peter B

[joel510]

Thanks for the reply.  I was aware of the DT/RT 2-3 part similarities.  Yes there quite a few bits in the US for them but I thought I'd give it a shot locally first.
Oh and I'm located in Colac, Victoria.
Joel