« previous next »
Pages: [1]   Go Down

Author Topic: Scored an RT-1MX cylinder today  (Read 969 times)

0 Members and 1 Guest are viewing this topic.

Offline Tahitian_Red

  • Legend
  • *****
  • Posts: 1109
  • Mugen ME480
    • View Profile
Scored an RT-1MX cylinder today
« on: September 08, 2012, 12:50:07 pm »
I found an RT-1MX cylinder today.  It is already bored to 1.25mm over.  I can get an aftermarket piston kit for 1.50 or 2.00mm, but man that seems big.  Is it safe to go that big?
Logged
The "Factory Novice"
California, USA

'74 Suzuki TM100, '75 Bultaco 250 Pursang, '77 Honda XR75, '77 Suzuki RM125B, '77 Yamaha YZ400D, '79 Honda CR250RZ Moto-X Fox Replica, '83 Honda ME480RD Mugen

Offline Iain Cameron

  • Legend
  • *****
  • Posts: 2015
    • View Profile
Re: Scored an RT-1MX cylinder today
« Reply #1 on: September 08, 2012, 01:36:37 pm »
Yeh Im running a 2mm over in mine  (comp is a bitch though) you will need a decompressor . Iain
Logged
Yamaha tragic ; dt1, rt1, dt2, rt2, dt2mx , rt2mx , mx250, mx360,sc500, 74dt125, yzx125, yzc250, yzc400, yzd250, yzd400, yzh250, yzh80 , dt100 , xr75 ko xr80 03 , it175 82 . Not a member of any club

Offline vandy010

  • Legend
  • *****
  • Posts: 1982
  • #789 MX125a BMCC Brisbane
    • View Profile
Re: Scored an RT-1MX cylinder today
« Reply #2 on: September 08, 2012, 03:10:40 pm »
2mm over is no problem.
then after you run out of genuine Yammy pistons,
you can move onto the TS 400 piston (with wrist pin mods) ;)
there still seems to be a good supply of piston port barrels on ebay.
Logged
"flat bickie"
Pages: [1]   Go Up
« previous next »