« previous next »
Pages: [1]   Go Down

Author Topic: Husqvarna WR250 1980  (Read 2854 times)

0 Members and 1 Guest are viewing this topic.

Offline bigk

  • Legend
  • *****
  • Posts: 2655
  • Kangaroo Flat Victoria
    • View Profile
Husqvarna WR250 1980
« on: April 20, 2011, 05:04:28 pm »
Was planning to take it to Broadford, but won't be able to make it. Race resto, nice & tidy, compliance plate intact. PM or email [email protected] for photo's & details. $4500, I may trade something. Hopefully some photo's will be loaded soon.
Cheers,
K
« Last Edit: April 20, 2011, 05:13:26 pm by bigk »
Logged

Offline paul

  • Legend
  • *****
  • Posts: 4957
    • View Profile
Re: Husqvarna WR250 1980
« Reply #1 on: April 20, 2011, 05:32:01 pm »

Logged

Offline GD66

  • Legend
  • *****
  • Posts: 1109
    • View Profile
Re: Husqvarna WR250 1980
« Reply #2 on: April 20, 2011, 07:22:39 pm »
I have one of these, unrestored, sitting in my garage : what's the bracket on the r/h fork leg for : a (shudder) speedo ?
I have a set of DC Plastics combination side cover/number plates to fit up.
Have diced the Clarke tank and woeful rear guard and will be trotting it out as an evo mx racer, 12" both ends will be something of a revelation after the 7 and 4 of my 1974 WR400.
Looks good, BigK, hope mine comes up as nice... ;)
Logged
Nostalgia's not what it used to be....

Offline bigk

  • Legend
  • *****
  • Posts: 2655
  • Kangaroo Flat Victoria
    • View Profile
Re: Husqvarna WR250 1980
« Reply #3 on: April 20, 2011, 08:34:11 pm »
The wire bracket on the RH fork is for the speedo cable.
Cheers,
K
Logged
Pages: [1]   Go Up
« previous next »