Just a throught I had a couple of mths back on wheel off setts and wheel alignment.,
Trying to get a bike to turn better cornering etc ,if the rear wheel is off sett 11mm to the front would that make cornering harder....
I can off sett my back wheels to suit the front but rather wait for the forum board to respond
I have measured three bikes one is 3mm,11mm and 10mm this is with true rims and stadard hub off setts to rims
I have lined the back wheels up spot on with the front cog to get the rear wheel square and straight
I used a alloy straight edge and measured from centre of rim front and rear of both wheels to get the bike in a straight line.
Then worked out the diffrence ....And I have made sure the front rim is centre of forks.....
I realise we are playing with old dirt bikes ,not super bikes on tar
And is modern bikes pretty spot on I dont have one to check
Its just something I havent seen pop up on here since Ive been on here (theres a young bloke up the top end i would say hes been down this line of throughts)
