Author Topic: Yamaha frames.  (Read 986 times)

0 Members and 1 Guest are viewing this topic.

Offline Nathan S

  • Superstar
  • ******
  • Posts: 7275
  • HEAVEN #818
    • View Profile
Yamaha frames.
« on: October 14, 2010, 12:00:33 am »
1. YZ125D, quite good, includes swing arm, shock, foot pegs, rear motor mount, triple clamps and rusty forks. $70.

2. YZ125C. Reasonable, minor damage at rear. Includes swing arm, foot peg mounts (and maybe the pegs themselves?). $40.

3. DT100A. Hacked to bits - good for repair sections/material only. Includes swing arm, triples and very rusty forks. $5.

4. DT125 (AT1 type). Good condition. Includes swing arm and triples. $15.

5. YZ125G. Has been repainted, but has been scratched due to rough handling. Includes triple clamps, footpegs w mounts, airbox and YZ125H swingarm. $80.



Happy to take pics if anyone wants them.

Maybe more of them when I go and have a looksee.

Yass, NSW.
04000 23847.
« Last Edit: October 14, 2010, 01:47:01 am by Nathan S »
The good thing about telling the truth is that you don't have to remember what you said.

Offline Shaun G

  • Legend
  • *****
  • Posts: 714
  • Sydney, NSW
    • View Profile
    • FULL LOAD MOTORCYCLE TRANSPORT
Re: Yamaha frames.
« Reply #1 on: October 14, 2010, 11:41:20 am »
Hey Nathan. I after a K model 125 frame or anything to suit a right hand drive for a little project I'm contemplating. Please let me know if you have anything.
Cheers
Shaun

Offline Nathan S

  • Superstar
  • ******
  • Posts: 7275
  • HEAVEN #818
    • View Profile
Re: Yamaha frames.
« Reply #2 on: October 14, 2010, 11:52:25 am »
G is RHD. Has side exhaust port rather than the K's centre port though.

Also have a badly hacked H frame if you wanted to dummy stuff up without cutting into a good frame?

The good thing about telling the truth is that you don't have to remember what you said.

Offline Shaun G

  • Legend
  • *****
  • Posts: 714
  • Sydney, NSW
    • View Profile
    • FULL LOAD MOTORCYCLE TRANSPORT
Re: Yamaha frames.
« Reply #3 on: October 14, 2010, 12:44:13 pm »
Nah I need a centre port....and my fabrication skills are zilch  :'( :'(

Cheers
Shaun