« previous next »
Pages: [1]   Go Down

Author Topic: KTM 80/81 38mm Marzocchi Forks  (Read 1799 times)

0 Members and 1 Guest are viewing this topic.

Offline BAHNZY

  • Legend
  • *****
  • Posts: 1149
    • View Profile
KTM 80/81 38mm Marzocchi Forks
« on: September 25, 2008, 12:27:03 am »
A quick question.
How do the 38mm KTM spec Marzocchi's stack up against the 38mm units from the Japanese manafactures at the time. ie: would it be an improvement to swap out the Japanese units for the KTM units?
Logged
Rod (BAHNZY) Bahn

oz555ktm

  • Guest
Re: KTM 80/81 38mm Marzocchi Forks
« Reply #1 on: September 25, 2008, 06:14:11 pm »
I think thay work fine.
Must use Good fork seals .

I think you would be a bit short.
 As Ktm have very long fork tubes

I would leave the Marzocchis on ya KTM ...
Logged

Offline Tahitian_Red

  • Legend
  • *****
  • Posts: 1109
  • Mugen ME480
    • View Profile
Re: KTM 80/81 38mm Marzocchi Forks
« Reply #2 on: September 30, 2008, 07:13:04 am »
I have these same forks on my 1981 Can-An MX-6.  You need to make sure the axle is centered, so that there is no binding throughout the stroke.  There is also a damper rod trick that Works Performance used on the 1978 Marzocchis that I have had done to mine, but have not tested them out yet.  I will be switching forks soon and will report how it worked here.
 :)
Logged
The "Factory Novice"
California, USA

'74 Suzuki TM100, '75 Bultaco 250 Pursang, '77 Honda XR75, '77 Suzuki RM125B, '77 Yamaha YZ400D, '79 Honda CR250RZ Moto-X Fox Replica, '83 Honda ME480RD Mugen
Pages: [1]   Go Up
« previous next »