Mikuni jet needle

[dirtrumpy]

Does anyone here have the specs for a mikuni 6dh20 jet needle? Can't find it anywhere, mikuni oz can't help either.

[bazza]

Do you mean  6DH2 ? = 62.3 mm long.  If so i have specs and can send (from old Mikuni manual)

[dirtrumpy]

No, it is the 6dh20 im after, mikuni oz have them in stock but strangely don't know the specs for them, can't find anywhere on the net either

[bazza]

Seems the 500cc Husky 1984 runs that needle. Seonosale says they have them and some on e/bay - perhaps see if those firms can give you specs?

[skypig]

No, it is the 6dh20 im after, mikuni oz have them in stock but strangely don't know the specs for them, can't find anywhere on the net either

What’s the cost of one?

[dirtrumpy]

Only around $15 and already on order. Just wondering where it sits relative to the others.

[bigk]

6DH20 is not a Husky 500 needle (7DH3). It is however used in some CR/WR125's & CR/XC250's. I don't have the specs but last time I checked one against the common Husky 6DH3 needle, it was longer by an obvious amount. I used one in a CR430 which would normally use a 6DH3 & it seemed to clean up the bottom & mid.
Cheers,
K

[bazza]

apologies husky rider said thats what his 84 needle was

[bigk]

No apologies required, his 500 may have one in it but it's not standard issue for 500's. I don't reckon it would work that well in  VM40 or VM44 though, they generally require 7 series needles.
K