« previous next »
Pages: [1]   Go Down

Author Topic: KX125 Idle Adjustment  (Read 1316 times)

0 Members and 1 Guest are viewing this topic.

Offline Kenneth S (222)

  • Administrator
  • Legend
  • *****
  • Posts: 897
  • Sydney, Australia
    • View Profile
    • 24 Hour T-shirts
KX125 Idle Adjustment
« on: April 17, 2015, 02:23:10 pm »
Putting this up for a fellow club member. He is getting a KX125 on the track, an 86 model, and he says there is no obvious idle adjustment. Any forum members have experience with this model?
He also says that the engine runs, but when he turns, it dies. Thoughts?
Logged
Kenneth S
Go For It

Heaven VMX Club - Racing No 222 - 79 CR250RZ - 84 CR250RE (Steam Train) - 89 CR250RK

Race Bike History
76 RM125A, 77 RM125B, 78 RM125C, RM400C, 79 CR250RZ, 80 YZ250G, 81 RM465X, 82-83 RM490 Frank Pons Special(Beetle's 81 Race Bike)

Offline TT5 Matt

  • Legend
  • *****
  • Posts: 1538
    • View Profile
Re: KX125 Idle Adjustment
« Reply #1 on: April 17, 2015, 06:45:46 pm »
i cant help with the idle adjustment or if it even has 1 but the cutting out when turning sounds like the kill switch wiring is damaged and shorting out on the frame/tripples trees/steering stops and the wiring needs repairs/replacement and rerouting
Logged

Offline Nathan S

  • Superstar
  • ******
  • Posts: 7275
  • HEAVEN #818
    • View Profile
Re: KX125 Idle Adjustment
« Reply #2 on: April 17, 2015, 07:38:03 pm »
Oval bore Mikuni has an idle speed screw, but no idle mixture adjuster screw.
Supposedly, you can tune them by swapping brass, but I've never been able to get them just right - apparently the emulsion tube is the key, if you're that keen.

As a general rule, most old bikes seem to be very rich on the pilot jet when run on modern pump fuel.
Logged
The good thing about telling the truth is that you don't have to remember what you said.
Pages: [1]   Go Up
« previous next »