Rubber Fork Boots from Pyramid Parts

[ghostrider]

 Has anyone bought these fork boots from Pyramid Parts on Evilbay? They sort of look like the goods , I am after some replacement fork boots for my rm125n and these look fairly close, and they claim to be actual rubber not silicone??

[VMX247]

WARNING Will Robinson
Wrong size ,wrong material/plastic.
Don't do returns.
WARNING Will Robinson

[oldyzman]

From Memory:
 fork seals - success
Wheel Bearings - success
Head stem bearings for my rz 90% success - i did have to reuse one part
Chain roller for my YZ250e - not fit
Fork gattors rather not comment as i am not totally sure they were the supplies of non fitting product
so i would say approx 75% Pass in some peoples books

In my trade if the job is 65% good it fails and people get let down or hurt

[Tomas]

Yep. Pyramid parts fork boots are shit. They about two inches shorter than they should be and are too tight for RM 125N 38mm forks. I got Daystar 58 series black fork boots and they are perfect fir. Made in USA too.

[oldfart]

And to add to the above, when forks are compressed they rub on your tyre ...... waste of money and so are the wet suit material wrap rounds.

[Mike52]

Go to your local bike shop.
Cheaper and they will fit.
Less hassle all round.

[ghostrider]

 Lucky I asked first, thanks for the heads up everyone.I think I better shop at the local where you can see up front ,,but then again I should have known....