carbie

[crs-and-rms]

looking for rm 125 s carbi

[Tim754]

The S models Mikuni carburettor was also quite larger and didn't have the tall top cap as the M model, and the carburettor intake rubber/alloy pipe was also larger and carried an adapter plate. The new carb had increased jetting values and a special needle valve orifice with three extra angular drilled holes to allow fuel to bypass the lower needle valve body into the bigger float bowl.


Suzuki RM125S 1975

[pmc57]

These are harder to find then the good old rocking horse poo, #41700 is the number but other 34mm Mikuni carbies I'm sure will do the job.

I too was seeking this elusive animal a while back, my luck must have been with me that day because not only did i find a carby body, I also found a M airbox in mint condition. Now I have two airboxes, one for my S the other to suit an M.

I still need some of the internals like a #2.5CA slide with idle cut-out on left hand side and key slot opposite.

[crs-and-rms]

i have one carbi thats the same size 34 mm  but the bowl sits to low and wont fit in