« previous next »
Pages: [1]   Go Down

Author Topic: Cross brace for alloy bars.  (Read 1931 times)

0 Members and 1 Guest are viewing this topic.

Offline Nathan S

  • Superstar
  • ******
  • Posts: 7275
  • HEAVEN #818
    • View Profile
Cross brace for alloy bars.
« on: January 20, 2008, 09:57:16 pm »
Well, I actually need the clamps that hold the cross-brace to the bars, in the standard 22.2mm (7/8") diameter.

Hopefully someone's got a set of bent alloy bars, or something?

0400023847
Logged
The good thing about telling the truth is that you don't have to remember what you said.

Offline LWC82PE

  • Superstar
  • ******
  • Posts: 6006
    • View Profile
    • PE motorcycles & SuzukiTS.com
Re: Cross brace for alloy bars.
« Reply #1 on: January 21, 2008, 08:51:36 am »
i will have a look today or tomorrow. i kn ow i had some, but not sure where they are or if i got them still
Logged
Wanted - 1978 TS185 frame or frame&motor. Frame # TS1852-24007 up to TS1852-39022

TM BILL

  • Guest
Re: Cross brace for alloy bars.
« Reply #2 on: January 21, 2008, 11:09:08 am »
Give me your address Nathan i will put them in the post Bill  :)
Logged

Offline LWC82PE

  • Superstar
  • ******
  • Posts: 6006
    • View Profile
    • PE motorcycles & SuzukiTS.com
Re: Cross brace for alloy bars.
« Reply #3 on: January 21, 2008, 12:04:05 pm »
no good here, i only got stipped ones
Logged
Wanted - 1978 TS185 frame or frame&motor. Frame # TS1852-24007 up to TS1852-39022

Offline gorby

  • B-Grade
  • ***
  • Posts: 229
    • View Profile
Re: Cross brace for alloy bars.
« Reply #4 on: January 21, 2008, 10:43:42 pm »
found any yet,nathan?
should have some if you still need them
Logged

Offline paul

  • Legend
  • *****
  • Posts: 4957
    • View Profile
Re: Cross brace for alloy bars.
« Reply #5 on: January 22, 2008, 11:55:52 am »
this any  good to you
Logged

Offline Nathan S

  • Superstar
  • ******
  • Posts: 7275
  • HEAVEN #818
    • View Profile
Re: Cross brace for alloy bars.
« Reply #6 on: January 23, 2008, 09:22:58 am »
Sorry for the slow reply gents...  :-[

The short answer is 'yes please' - I actually need a couple of sets, and a third pair wouldn't go astray.


I'll send some PMs. :)
Logged
The good thing about telling the truth is that you don't have to remember what you said.

Offline paul

  • Legend
  • *****
  • Posts: 4957
    • View Profile
Re: Cross brace for alloy bars.
« Reply #7 on: January 23, 2008, 09:31:51 am »
nathan send me your address  and i will wack it in the post
Logged
Pages: [1]   Go Up
« previous next »