DT250 and 400 monoshock hubs.

[Nathan S]

I have the rear hubs from each of these bikes
Bare hubs only, although I might have the spokes for the 400.
Good useable condition.

The 250 hub is similar to the earlier MX250A type hub (NB: Not the same - they take a different sprocket) and would be an easy way to get rid of the cush drive on a DT250/360A.

Come and take 'em away or they end up in the scrap pile.

04000 23847

[Nathan S]

250 hub claimed by Vandy.

400 hub still available.

[firko]

Gone Nathan.......I'll have that 400 hub if you don't mind. Do you have a spare backing plate as well? If so, I woulldn't mind it.

[vandy010]

if Nathan hasn't got a backing plate i'll probably have a DT400 one here somewhere. will look over the weekend.

[Nathan S]

Sorted Firko. Pretty sure I don't have a monoshock backing plate (lug rather than torque arm), but probably have a twin-shock one. Will check tomorrow.

[vandy010]

found a backing plate, PM sent to firko

[Nathan S]

Sorted Firko. Pretty sure I don't have a monoshock backing plate (lug rather than torque arm), but probably have a twin-shock one. Will check tomorrow.

Funny that... turns out that I do have the monoshock brake, but no spare twinshock ones.