« previous next »
Pages: [1]   Go Down

Author Topic: RM125T carby  (Read 1296 times)

0 Members and 1 Guest are viewing this topic.

Offline rmyzit

  • C-Grade
  • **
  • Posts: 59
    • View Profile
RM125T carby
« on: February 21, 2012, 01:31:53 pm »
Hi all. The carby I have on my RM125T is not the standard size and the bore is worn. The venturi measures 36mm by my verniers, the standard carb should be 32mm. So I have decided to buy a new 32mm mikuni while our aussie dollar is on a high.
Can some one suggest jetting and slide sizes they have found to work for vmx use before I order?
My engine is standard, no porting or exhaust mods.
Evo
Logged

Offline Davey Crocket

  • Legend
  • *****
  • Posts: 4408
    • View Profile
Re: RM125T carby
« Reply #1 on: February 21, 2012, 01:44:52 pm »
The parts book will tell you all the jets/needle, slide etc.....just order it with the correct parts.
Logged
QVMX.....Australia's #1 VMX club......leading the way.

Offline bazza

  • Legend
  • *****
  • Posts: 2353
    • View Profile
Re: RM125T carby
« Reply #2 on: February 21, 2012, 02:13:21 pm »
or by off Hatrix??? Auzy company,good to deal with, pre jetted some Mikunis
Logged
Once you go black  you will never go back - allblacks
Maico - B44 -1976 CR250- 66 Mustang YZF450,RM250
Embrace patina

Offline rmyzit

  • C-Grade
  • **
  • Posts: 59
    • View Profile
Re: RM125T carby
« Reply #3 on: February 21, 2012, 09:23:36 pm »
Unfortunately not having a parts book or workshop manual......... yet, I've been digging deep into the achives and found this: http://ozvmx.com/community/index.php?topic=13428.0
Anyone agree or disagree with these specs?
Logged
Pages: [1]   Go Up
« previous next »