Author Topic: MX vs DT cylinders  (Read 7682 times)

0 Members and 1 Guest are viewing this topic.

Offline Freakshow

  • Superstar
  • ******
  • Posts: 7277
  • Adelaide, SA - looking for a "YZA" tank
    • View Profile
Re: MX vs DT cylinders
« Reply #15 on: November 07, 2011, 11:40:09 pm »
34mm is the standard MXA carby so why would you run anything else ?

30mm was standard ;).

Like i said MXA where 34mm
74 Yamaha YZ's - 75 Yamaha YZ's
74 Yamaha  flattracker's
70  Jawa 2 valve speedway's

For sale -  PRE 75 Yamaha MX stuff, frame, motors and parts also some YAM DT1,2,A and Suzi TS bikes and stuff

mx250

  • Guest
Re: MX vs DT cylinders
« Reply #16 on: November 07, 2011, 11:52:22 pm »
................ mine again is fitted with points, but some others claim they come standard with elec ignition.
I'm with Nathan on this - I'm 99.9% certain they all came standard with internal rotor CDI.

I swapped to the flywheel maggy for endruo - a great mod - pulled like a four stroke and revved like a two stroke 8).

Offline firko

  • Superstar
  • ******
  • Posts: 6578
    • View Profile
Re: MX vs DT cylinders
« Reply #17 on: November 08, 2011, 07:29:21 am »
Quote
I'm with Nathan on this - I'm 99.9% certain they all came standard with internal rotor CDI.
Me too.
Dunno about the 34mm carby though ::).
'68 Yamaha DT1 enduro, '69 Yamaha 'DT1 from Hell' '69 DT1'Dunger from Hell, '69 Cheney Yamaha 360, 70 Maico 350 (2 off), '68 Hindall Ducati 250, Hindall RT2MX, Hindall YZ250a , Cycle Factory RT2MX flat tracker, Yamaha 1T250J, Maico 250 trials, '71, Boyd and Stellings TM400, Shell OW72,750 Yamaha

Offline Lozza

  • Legend
  • *****
  • Posts: 4206
    • View Profile
Re: MX vs DT cylinders
« Reply #18 on: November 08, 2011, 12:53:26 pm »
Your DT still going Nathan?
Jesus only loves two strokes

Offline Nathan S

  • Superstar
  • ******
  • Posts: 7275
  • HEAVEN #818
    • View Profile
Re: MX vs DT cylinders
« Reply #19 on: November 08, 2011, 01:59:37 pm »
Which one?

The DT- powered MX250 copped the mother of all over-revs at Canowindra (not me!) and now has a multi-part piston - and rings through the main bearings.
The DT125 needs a rod after it swallowed dirt about four years ago... I've got the new crank ready to go in, but haven't found the time and motivation together in four years....
The good thing about telling the truth is that you don't have to remember what you said.