« previous next »
Pages: 1 [2]  All   Go Down

Author Topic: YZ125H Steering stem remake  (Read 3536 times)

0 Members and 1 Guest are viewing this topic.

Offline Mike52

  • Legend
  • *****
  • Posts: 1834
  • 81 KTM 125 LC
    • View Profile
Re: YZ125H Steering stem remake
« Reply #15 on: May 25, 2011, 01:26:30 pm »
I,ve machined Titanium.
Had to shorten an imported Prince Albert thingy for a mate ::)
Didn,t like to touch it in case it was second hand :o but it machined up real nice. :)
Logged
85/400WR,86/240WR,72/DKW125,Pe250c,TC90,TS100,XT250,86/SRX250,XR400r
Friend  struggling up a hill on a old bike at MTMee .http://www.youtube.com/watch?v=cjj6E2MP9xU.

cheapracer

  • Guest
Re: YZ125H Steering stem remake
« Reply #16 on: May 25, 2011, 11:57:16 pm »
Quote from: GMC on May 25, 2011, 10:55:05 am

If making a new shaft you can also consider making it to suit readily available seals if applicable.

You could consider 1020 mild steel which can be bought as hollow bar. This makes it easier to bore out the middle if any.


2 mighty fine ideas right there.
Logged
Pages: 1 [2]  All   Go Up
« previous next »