Author Topic: Won't damn well run  (Read 5204 times)

0 Members and 1 Guest are viewing this topic.

Offline Canam370

  • Legend
  • *****
  • Posts: 1608
    • View Profile
Re: Won't damn well run
« Reply #15 on: May 20, 2010, 09:27:02 am »
Harumph! Whatta ya mean Big K?  :(
WANTED. Canams;all models,complete or parts.SWM stuff too!

I'm THE Thread Killer - when I post a thread dies!

DR

  • Guest
Re: Won't damn well run
« Reply #16 on: May 20, 2010, 09:46:40 am »
 :D Canam had it by the short and curlys..(no disrespect intended Curly ;))

does the CR have a bridged or non bridged exhaust post. You may need to drill a couple of small relief holes in the skirt to aid lubrication on the exhaust side :-\

Offline vmx42

  • Legend
  • *****
  • Posts: 1579
    • View Profile
Re: Won't damn well run
« Reply #17 on: May 20, 2010, 10:03:29 am »
They went on the snow trip ignoring the light, a good couple of hours each way. When they returned they drove back into the workshop and it was then they looked over to see the oil pump was still sitting on the work bench. :o

Couldn’t do that with a Jap car these days.

Probably the only time a 'Lucas' warning light was right…  ;D
When a woman says "What?", it's not because she didn't hear you, she's giving you the chance to chance to change what you said.

Beam me up Scotty, no intelligent life down here…

"everyone is entitled to their own opinion, but not to their own facts"

Offline bigk

  • Legend
  • *****
  • Posts: 2655
  • Kangaroo Flat Victoria
    • View Profile
Re: Won't damn well run
« Reply #18 on: May 20, 2010, 04:39:48 pm »
No need to get upset Canam, Darren actually called me.
K

Offline JohnnyO

  • Legend
  • *****
  • Posts: 4658
  • Qld
    • View Profile
Re: Won't damn well run
« Reply #19 on: May 20, 2010, 05:28:19 pm »
Big K was right, spose this'd do it.. ::) ::) ::)


You didn't feel it siezing or notice the lack of compression afterwards??

Offline Canam370

  • Legend
  • *****
  • Posts: 1608
    • View Profile
Re: Won't damn well run
« Reply #20 on: May 20, 2010, 06:19:44 pm »
No need to get upset Canam, Darren actually called me.
K
 
  ;D :-* What, you're telling me there are people operating outside of the forum?! This is how things get all confused!
WANTED. Canams;all models,complete or parts.SWM stuff too!

I'm THE Thread Killer - when I post a thread dies!