« previous next »
Pages: [1]   Go Down

Author Topic: repairs to rear rail  (Read 1711 times)

0 Members and 1 Guest are viewing this topic.

oldfart

  • Guest
repairs to rear rail
« on: December 22, 2009, 10:49:26 pm »
Rm 400 T rear rail repairs
3 out of the 4 frames I have had to perform this task so will pass it on
Bend tube with 3/4 copper pipe benders at 20 degrees
Logged

oldfart

  • Guest
Re: repairs to rear rail
« Reply #1 on: December 22, 2009, 10:52:26 pm »
Logged

oldfart

  • Guest
Re: repairs to rear rail
« Reply #2 on: December 22, 2009, 11:00:39 pm »
 Mark up a reference point on frame- and note down position of seat & muffler mounts. ( take a pic ) before cutting as close as possible to intersecting point. * note measure twice cut once.
 
« Last Edit: December 22, 2009, 11:02:44 pm by oldfart »
Logged

oldfart

  • Guest
Re: repairs to rear rail
« Reply #3 on: December 22, 2009, 11:09:51 pm »
Drill two 6mm holes in frame rail (top & bottom ) & the same with new section 10mm in from each end .
Make up a short dowl section 30mm long thsat will fill in frame rail plus new section .
Logged

oldfart

  • Guest
Re: repairs to rear rail
« Reply #4 on: December 22, 2009, 11:13:21 pm »
Logged

oldfart

  • Guest
Re: repairs to rear rail
« Reply #5 on: December 22, 2009, 11:20:50 pm »
Intermission .....Getting RSI, time for a cuppa Tea.

Logged

Offline Davey Crocket

  • Legend
  • *****
  • Posts: 4408
    • View Profile
Re: repairs to rear rail
« Reply #6 on: December 23, 2009, 07:37:32 am »
How longs it take for a cuppa Stewie?  I hope thats chrome moly!!!!. Did you get the welding rods?.....Merry Christmas mate.
Logged
QVMX.....Australia's #1 VMX club......leading the way.
Pages: [1]   Go Up
« previous next »