« previous next »
Pages: [1]   Go Down

Author Topic: jetting for IT250k  (Read 2286 times)

0 Members and 1 Guest are viewing this topic.

Offline mxmaniac

  • Legend
  • *****
  • Posts: 687
    • View Profile
jetting for IT250k
« on: April 30, 2009, 09:49:43 pm »
Anybody have any reccommendations on improved jetting specs on a standard IT250k? It only has a after market muffler other than that its all standard.
Logged
Maico's, the only way to go.

Offline shortshifter

  • Legend
  • *****
  • Posts: 667
  • Sunshine Coast QLD
    • View Profile
Re: jetting for IT250k
« Reply #1 on: May 19, 2009, 04:42:19 pm »
main jet 380     needle jet n-8  pilot jet 40   jet needle 6f34  clip position 4 float level 24mm.I think I'm running a 390 main jet.
Logged

Offline Tim37

  • C-Grade
  • **
  • Posts: 119
  • Its an investment ...had to buy it !
    • View Profile
Re: jetting for IT250k
« Reply #2 on: July 18, 2009, 09:58:35 pm »
The best thing to do with ANY Jap bike is...
 remove the petrol cap hold onto this ,wheel into its place any european bike , fit the cap and all will be well with your world , especialy when you ride !cheers Tim
Logged

Offline XR

  • Novice
  • *
  • Posts: 30
    • View Profile
Re: jetting for IT250k
« Reply #3 on: July 19, 2009, 09:13:11 am »
So what your trying to say is, the JAP fuel cap should make the european bike start eventually, and run properly????
Logged

Offline mxmaniac

  • Legend
  • *****
  • Posts: 687
    • View Profile
Re: jetting for IT250k
« Reply #4 on: October 17, 2009, 05:07:54 pm »
Thanks fellas
Logged
Maico's, the only way to go.
Pages: [1]   Go Up
« previous next »