Topics

1

Wanted / Wanted 1974 TS100 petrol cap

« on: March 20, 2019, 08:58:03 pm »

Hey,
I am on the hunt for a 1974 TS100 (small hole) petrol cap. I brought one, but it's too big. Need it in a hurry, PLEASE HELP! Leads appreciated

Thanks,
Mark

2

Wanted / 1968 Suzuki T200 Crank NEEDED

« on: December 11, 2018, 08:41:39 pm »

Hi,
I had my crank pressed apart and the bearing surfaces are no good. It must of been sitting in water for 20 years. I got hold of a second bottom end and it is stuffed too! If you have a T200 crank weighing you shelf down, please give me a call. Cheers Mark 0408271831 

3

Wanted / 1968 Suzuki T200 X5 Scrambler Crank pins

« on: October 24, 2018, 05:57:51 pm »

Hi all,
I have been trying for months to get my hands on a pair of crank pins. Mine are rusted solid, along with just about every moving part. Even the carbs were festered into solid blocks. Have got everything together minus the crank pins. Good used ones or new would be super helpful!
Any help would be greatly appreciated
Thanks,
Mark

4

Wanted / Wanted IT490 Black Fork Boots

« on: October 19, 2018, 11:53:08 pm »

Any ideas on fork boots without expensive o's postage?

5

Wanted / XT500 HL style, small parts needed

« on: January 22, 2018, 07:19:57 pm »

Hi all,
I put my bike on the back burner, (again) for a while now. Looking to finish her off. I need,
Headlight ring (I have one with a few scars)
Mirrors
Steel rear guard
Cable guide (mounts on front fork leg)
Rear tail light

Planning to put her on Historic rego. Any help appreciated.
Cheers Mark

6

Wanted / Wanted 18" paddle tyre, or Any Outragous 18" rear 21" front combination

« on: September 10, 2016, 12:18:05 pm »

Hey,
Anyone got a sand tyre in good Nic? 18" rear Thanks 0408271831 Mark

7

Wanted / XT 500 or XT600 Bits needed

« on: March 04, 2016, 09:00:53 pm »

Hi all,
I have returned to my rebuild after a lengthy abstinence. It got the better of me for a while, but have seen the light at the end of the tunnel ?
Has anyone got a toasted engine case for xt600 or a xt500
An aluminum bash cover for a XT500 in polishable condition

Any help appreciated
Mark

8

Tech Talk / Thread die or spec for YZ125 aluminium tank

« on: April 04, 2015, 10:44:50 pm »

Hi all,
Does anyone know the thread die required to clean up a dodgy thread on a YZ125 aluminium tank? Any advice appreciated, Mark

9

Wanted / XT600 parts For my HL595 rebuild

« on: November 01, 2014, 07:28:46 am »

Looking for parts for a 84 (ish)XT600, trying to fit the engine in my HL500 (XT 500) style rebuild.
Rectifier
Engine to case clutch cable bracket
Left and right foot pegs with rod rear brake - kick lever fowls on the XT pegs
Ignition switch
Wiring harness
Throttle and cables
Flasher

Digital Speedo (old style) as I can't use a cable

10

Wanted / XT500 L and R foot rests

« on: October 26, 2014, 07:02:39 pm »

Hi
Need XT 500 (1978) left and right foot pegs.
Cheers, Mark

11

Wanted / 18" inch paddle tyre

« on: September 14, 2014, 07:21:15 pm »

Hi,
Has anyone got a 18" rear paddle tyre?
Cheers Mark

12

Wanted / XT500 Rear Rim, I have the rest

« on: June 15, 2014, 07:16:58 pm »

Hey,
Anyone have a rear rim for a 1977 XT500. I started to polish a rim, but found a dirty big crack. I have the spokes and hub. Cheers Mark

13

Wanted / TT500 Aluminium Swing Arm Rear Brake Pedal (external linkage)

« on: May 28, 2014, 09:41:01 pm »

Hi,
I'm keen to get the genuine TT500 rear brake pedal, with the external linkage. If you have one but don't want to part with it I would be keen to take a paper traceable copy, so I can reproduce the arm. Any help appreciated. Cheers Mark

14

Wanted / XT500 (1977ish) Frame

« on: April 28, 2014, 07:40:17 pm »

Hey men of two wheels,
Just finished building a gusset for a crack in the L/H lower, near the peg of my 1977 XT500, and then noticed some strange welding on the front engine mount. I ground it back and it's got a braised engine mount. Might opt out of this frame if I can get another. Give me a call on 0408271831 if you have a frame spare. Big Thanks Mark

15

Wanted / Project build Shocks 16 or 17 inch eye eye

« on: March 06, 2014, 01:09:30 pm »

Hi,
Trying to balance my XT500, I would like to try 16 or 17 + inch shocks. Not to fussed on brand, but required in usable condition.

Thanks,
Mark