1
Wanted / Re: project
« on: January 13, 2017, 12:02:03 pm »
PE 250 B / C
Show Posts
This section allows you to view all posts made by this member. Note that you can only see posts made in areas you currently have access to.
Pages: [1]
3
Suzuki / Re: RM 250 A, B and C Swingarm dimensions
« on: November 14, 2016, 11:54:26 am »
As an aside - After I had a PE250C swing arm sandblasted and powdercoated, the 216mm opened out to 221mm..I had to put the swing arm into a press to close it back up again.
John
John
4
Wanted / Re: Wanted 1975 RM 125/ TM 125 SEAT
« on: August 24, 2016, 02:49:35 pm »
I have a PE175 Seat - not sure of age nor if it will fit.
I'm in Tassie - $40 + Postage and it's yours.
Cheers
John
I'm in Tassie - $40 + Postage and it's yours.
Cheers
John
5
Suzuki / Re: Suzuki RM125B alloy tank WANTED
« on: August 01, 2016, 09:29:00 am »
I have one in Kallaroo (Whitfords), I'll phone to discuss.
Cheers
John
Cheers
John
6
Suzuki / Re: Suzuki RM370 frame andswingarm
« on: June 28, 2016, 02:17:37 pm »
Richo hi
I have a bare PE250B roller available. Un-restored but in good condition. Any use to you?
John
I have a bare PE250B roller available. Un-restored but in good condition. Any use to you?
John
Pages: [1]