1
General Discussion / Re: tt600
« on: August 20, 2017, 07:39:47 pm »
Is it possible to swap about dual carbs to single carb
Show Posts
This section allows you to view all posts made by this member. Note that you can only see posts made in areas you currently have access to.
2
General Discussion / tt600
« on: July 09, 2017, 09:54:27 am »
Hi all I purchased a 1998 tt600 which I would like to fit motorcross fairings but can't find anything on the net if anyone knows how to or know of a site where I can have a look would be great.
3
Introductions / Re: New guy from Wollongong
« on: October 16, 2013, 09:06:05 pm »
Your more then welcome glen glad to see someone will be able to get it back to its glory.
Keep the photos of build look forward to see it.
Keep the photos of build look forward to see it.
5
Introductions / Re: New guy from Wollongong
« on: October 10, 2013, 05:48:41 pm »
Anyone after a yz465 project as I don't have time or room to complete project so has to go open to offers would like to sell together and buyer to pick up or organize freight.
6
Introductions / Re: New guy from Wollongong
« on: October 08, 2013, 06:21:18 pm »
Yer intake has cracks on it but not all the way through but will looking at getting another down the track.
7
Yamaha / Re: Clutch settings
« on: October 07, 2013, 08:07:54 pm »
Thanks for the response what I am wanting to know is how far down do I screw the springs down.
8
Introductions / Re: New guy from Wollongong
« on: October 07, 2013, 07:40:27 pm »
Engine painted just need a few things to finish off it.
9
Yamaha / Clutch settings
« on: October 07, 2013, 07:30:03 pm »
Does anyone know how to set clutch springs on a 1980 yz465 as I'm new to clutch side of things.
10
General Discussion / Sell whole bike or part out
« on: October 06, 2013, 10:15:02 pm »
Just wondering do you seem to get more selling whole bike or selling parts?.
11
General Discussion / Where to get bearings in Australia
« on: October 06, 2013, 05:37:10 pm »
Where is a good place to go and get new bearings to replace the old bearings in Australia.
12
General Discussion / What's the best sway to clean swingarm
« on: October 05, 2013, 07:31:40 pm »
I have the swingarm off my yz465 which I want to polish up what's the best way to clean ?.
13
General Discussion / Will a 1982 Yamaha IT 465 Air Box fit a 1980 yz465?.
« on: October 02, 2013, 09:39:00 pm »
Will a 1982 Yamaha IT 465 Air Box fit a 1980 yz465?.
14
General Discussion / Suction hose on yz465
« on: October 01, 2013, 08:17:22 pm »
I was wondering where and what the suction hose behind kick starter on crankcase does and where it goes as I can only find part on list I have waiting for cd with manual to turn up.
15
Yamaha / Re: Yz465 Push Lever Assy stuck
« on: October 01, 2013, 04:58:56 pm »
Just pulled clutch about all looks good what should the springs be done up to.