Messages

1

Wanted / Re: 79/80 Honda CR125 cylinder

« on: January 09, 2014, 12:19:42 pm »

Hi Jimson, If you wanted to split barrel for bigk, and bigk was agreeable, I would be very interested in the bottom end!

Cheers,

Steve.

2

Wanted / Re: Wanted 1979/80 CR125RZ/RA/RB Transmission washer 90457-700-305

« on: May 03, 2013, 11:42:37 am »

Yes Rookie, I have always been mainly hooked on the red ones, Off and On Road!
Currently have a CR125RY just for a bit of fun with my youngest, but I'm also rebuilding an RA motor (slowly).
I am on the look out for an old RZ/RA basket case to play with.. the RH chain driven Elsinores are of the era I grew up in 

I've googled websites, Ebay, David Silver in the UK etc, sounds like this washer was made obselete by Honda a long time ago, even the complete shafts I see on Ebay in the States do not seem to have them fitted (I think it must stick on the inside of the LH case on disassembly and gets lost/mislaid).

Even if I can get the thickness of one I could then make one up - it is just a plain hardened thrust washer..

Cheers,

Steve.

3

Wanted / Wanted 1979/80 CR125RZ/RA/RB Transmission washer 90457-700-305

« on: May 02, 2013, 07:57:35 pm »

Hi Guys,

Can anyone help, I'm looking for a 15mm Thrust Washer Part No. 90457-700-305.  it sits on the l/hand side of the countershaft on a CR125 RZ /RA / RB, (spigot end, opposite end to the front sprocket)

Or, if anyone has a decent Countershaft off a 1979/1980 CR125RZ or CR125RA with this washer on it I would consider that too.

Cheers,

Steve.