OzVMX Forum

Marque Remarks => Husqvarna => Topic started by: Husabergpete on October 07, 2009, 02:34:38 pm

Title: 84 Swingarm Bearing Numbers?
Post by: Husabergpete on October 07, 2009, 02:34:38 pm

Can anyone tell us the code number for the 4 needle bearings which go in the swingarm pivot of an 84 Husky 250.

Ta

Pete

Title: Re: 84 Swingarm Bearing Numbers?
Post by: PEZBerq on October 09, 2009, 09:58:18 pm

I used a SKF HK2016-2RS I believe.  Be careful fitting them.  I put them in the freezer and tap them in with a hammer using a socket as a drift.  A little grease in the swing arm helps.  Final installation done using a G clamp to gently push them into the swingarm just far enough so the O-ring seal seats properly.

Title: Re: 84 Swingarm Bearing Numbers?
Post by: Husabergpete on October 12, 2009, 02:50:51 pm

Many thanks.